Marine Maintenance Menu
Motor Performance/Major Tune Up
Recommended every 3 to 5 years.
Mercury or Yamaha Outboards
- Horse Power
- Cycle
- Starting At
- 4.5-6-7.5-8-9.8 (110)
- 1&2 cyl
- $232.00
- 20-35-40 (402)
- 2 cyl
- $307.00
- 45-50-70-85-90
- 4 cyl
- $430.00
- 50-65-(650)-85(850)
- 3 cyl
- $413.00
- 90-115-140-150
- inline 6 cyl
- $552.00
- 135-150-200-225
- V-6
- $580.00
Tune Up Includes
- Spark Test.
- Set Engine Idle.
- Compression Test.
- Replace Gear Lube.
- Set Maximum Timing.
- Replace Fuel Filter.
- Replace Spark Plugs.
- Rebuild Carburetors.
- Replace or Rebuild Fuel Pumps.
- Set Carburetor Synchronization.
- Set Primary & Secondary Timing.
- Replace Carburetor Needle & Seats.
- Set Carburetor Fuel & Air Adjustments.
- Replace Carburetor Floats (V-6 Optional).
Inboards Chevy and Ford
- Cylinders
- Starting At
- 4 & 6
- $150.00
- V-8
- $200.00
Tune Up Includes
- Set Engine Idle.
- Compression Test.
- Replace Gear Lube.
- Set Engine Timing.
- Replace Spark Plugs.
**Motors not listed are by estimate only**
- Lube-Oil-Filter
- Lower Unit Service
- Stern Drive Service
- Recommended yearly
- Recommended yearly
- Recommended yearly
- All Models Inboard - $120.00
- All Models Inboard - $80.00
- All Models Inboard - $100.00
Water Pump Impeller Service
- Inboards and Outboards
- Starting At
- 4.5 - 260 Horse Power
- $130.00 + Parts
Recommended yearly service.
**Complete water pump rebuild by estimate only**
System Checks
- Service
- Price
- Computer Diagnostic Check
- $65.00 + hourly rate
- Charging System and System Circuit Check
- $85.00
- Battery Test
- $40.00
- Battery Replacement
- $40.00
- Battery Terminal Service
- $25.00
- Complete Ignition System (Outboard)
- $95.00
- Fuel Pump Pressure Check
- $85.00
- Shift and Throttle Checks
- $85.00
Prepurchase Inspection (A Must When Purchasing a Used Boat)
- Type
- Price
- Outboards (All Models)
- $85.00 motor only
- Inboards (All Models)
- $130.00 motor only
Inspect Entire Boat Add $40.00
20 Hour Check
- Type
- Price
- Outboards (2 Stroke)
- $104.00
- Outboards (4 Stroke)
- $129.00
- Inboards (All Models)
- $225.00 + up
Outboard Includes
- Test Run.
- Check Timing.
- Check Shifting.
- Change Gear Lube.
- Check Carb Synchronization.
- Lubricate Fittings on Motor.
- Check Engine Mounting Bolts.
- Check Trailer Tires and Alignment.
- Torque Head Bolts (if applicable).
- Check all Gauges, alarms, lighting and instrumentation.
Inboard Includes
- Test Run.
- Check Shifting.
- Change Gear Lube.
- Change Oil and Filter.
- Check Engine Alignment.
- Check Timing and Dwell.
- Check Engine Mounting Bolts.
- Check all Gauges and Alarms.
- Lubricate Fittings on Trailer.
- Check Trailer Tires and Alignment.
- Check lighting and instrumentation.
- Lubricate Fittings on Motor and Drive Unit.
Summerization
Inboard - $50.00
Include
- Check all fluids; engine oil, gear oil, power steering and antifreeze.
- Test run moter and check for leaks: check water pump for proper operation.
- Install all plugs, hoses, hoseclamps, and petcocks (removed at winterization).
Outboard - $45.00
Include
- Check Gear Lube.
- Test run motor for proper operation.
- Check water pump for proper operation.
Winterization
Inboard - $225.00 + up
Include
- Drain water pump.
- Replace gear lube.
- Replace fuel filter.
- Clean Flame arrester.
- Replace oil and filter.
- Fog motor with fogging oil.
- Drain interior water systems.
- Test run motor with stabilizer.
- Remove prop and grease prop shaft.
- Add gas stabilizer in to fuel tank.
- Install drive unit(new gasket kit).
- Remove all petcocks, plugs and hoses.
- Test run motor for new oil circulation.
- Remove drive unit to check engine alignment.
- Open petcocks to flush contaminants from motor.
- All plugs, hose clamps, petcocks are hung in bag on steering wheel.
- Lubricate: Swivel brackets, Gimbal bearing, U-joints, Bearing buddies, steering, tilt tube.
** 1992 Alpha One Generation II, Bravo One and Two, slightly higher**
Outboard (2 Stroke) - $105.00 (OptiMax slightly more)
Outboard (4 Stroke) - $140.00 + up
Include
- Replace gear lube.
- Fog motor with fogging oil.
- Add gas stabilizer into fuel tank.
- Remove prop and grease prop shaft.
- Test run motor with gas stabilizer.
- Winterization tag on Steering wheel.
- Lubricate: Swivel Brackets, Bearing Buddies, Steering, Tilt Shaft.
Shrink Wrapping Available
*by estimate only*
Boat Appearance Reconditioning
Buffing and Waxing and Engine Degreasing
Boat Trailer Services
Include
- Tire Repair.
- Roller Alignment.
- Wheel Bearing Service.
- Winch Stand Adjustment.
- Trailer Tracking & Alignment.
- Electrical Wiring and Repairs.
- Metal Repair & Paint Refinishing.
**All Prices Subject to Change**